Back to Main List |
Now you need to attach the foam to the rail. Put the foam on the ground and center the rail, upside down, on top of it. Use a Sharpie to trace a line around the inside and the outside of the rail. At this point I put some numbers around the rail and the foam so I'd know exactly where to place the rail it when I glued it.
Then you'll need to create some spacers to draw a line 1" around the inside of the rail and 1 3/4rds inches line around the outside of the rail. I used pegboard again to make custom spacers and it worked great.
Then take the rail off the foam and start a-cutting along the lines you made
with the spacers.